Why doesn’t my Lee Enfield shoot well? I use good bullets
and follow the reloading manual instructions to the letter.
Your rifle will only shoot well if it is fed quality ammunition. For reasons long forgotten, bullets made by modern
manufacturers are all undersized. They are either .311 or .312 inches in diameter. In short, today's bullets are too small! What?!? It's true. The original plans for the
P14 and Lee Enfields called for a .313 to .316 inch diameter barrel. They were rejected if found bigger
than .317 when inspected. That means if you want your rifle to perform, your reloads need the right size bullets!
A number of armourer’s instructions have been published
since the beginning of the 20th century. Regardless of which addition you read or its country of origin, barrel
diameter was designed to be between .313 and .314. The original drawings stated 0.3143. That’s
why Sierra’s .311 and Hornady’s .312 diameter bullets may not group too well in your rifle.
Machining practices in the early part of the 20th
century were crude by today’s standards. Nevertheless, you should slug your rifle’s bore to
determine its actual size. You’ll be shocked to learn that your rifle barrel isn’t .311! That’s
why cast bullet shooters get better results. They make bullets of the right size and ease back on velocities.
The bottom line? 303 British barrels will vary by several thousandths of an inch.
The diameter difference was NOT usually caused by wear, but rather, less precise
machining tolerances. That was why armourers and factory inspectors employed special bore gauges to determine barrel serviceability.
What does that mean for you? For precision shooting, consider using cast bullets.
Here is the math behind barrel size:
The 303 British is called a 303 because of the measurement between
the lands, which was 0.303 of an inch.
The depth
of the grooves was 0.005 to 0.0055 inches. Some publications list it as great as 0.008 inches. In any case,
you double the groove depth and add the result to the bore diameter to determine the correct bullet diameter.
Example:
0.303 + (2 x 0.005) = 0.313 inches
Shooting bullets that are closer
to the actual diameter of your rifle’s barrel will increase its accuracy. It will make you happier
too!!
---
2010 Update: Ruger’s technical department
says that their newly manufactured No 1 single shot barrels are made according to original specs – .314 to .316 inches.
Yes, you read that right! This has been verified by a number of shooters that have slugged their bores.
